But, I found that if I changed from whichever input I started the unit up on to another input after full power-up the sound worked just fine. Also, I have zero sound coming from the tuner as well. One is L703 and the other is L7001. In any other mode, there's a terrible squeal in all of the speakers. Small: Select if the surround back speaker is small. Pulled the 2R2 from the headphone jack and put it on L7002 and viola! By the way, the L7002 coil is coated with black plastic and roughly as big as a particle of small raw rice or a little bit smaller than 1N4001 diode. I plugged it back in this week and suddenly it was working fine, so i hooked it up in my bedroom and it worked all day yesterday but this morning no sound again.
All functions seemed operational but I could not get any sound out of my unit. In fact, in setup when adjusting speaker levels, when on Subwoofer the sound actually comes out of the center speaker, and vice versa. The receiver still makes a clicking sound when the audio should appear but it'd dead silence. Also, I have noticed that if I turn up the volume to around 40 and wait a few minutes, it suddenly starts making noise and then sound. I have the schematic and need help finding the choke coil.
We had our receiver quit playing audio, and I tried everything. Preset your favorite radio stations again The power cord has not been connected to a page 35. I don't use headphones, so I pulled it off the headphones board and soldered to the L7002 spot and it started working again. I performed the same swap and now my receiver works. The company also offers a 5. If you hook your Control 1s to that Onkyo, it won't sound great and could cause the receiver to overheat and trip the protection circuit if played at high volume. I was delighted to reassemble it and find out that it worked.
Which did you all swap with? I can not get any sound out of it at all. I have the schematic and need help finding the choke coil. I have yet to complete this fix you mentioned. Which did you all swap with? Pulled the 2R2 from the headphone jack and put it on L7002 and viola! L7002 under the ribbon by the connector. Maybe I'll call them up when I setup another surround system at some point. Very good condition and priced to sell. Sooo, I decided investigate the problem myself.
Sometimes when you selected the channel both the image and the sound would not come though. I'm not ready to get rid of it yet, but it only produces a decent sound through the Direct listening mode. The Bad Big, boxy speakers with uninspired styling. It is labled 2R2 in white. If I switch from input to input, the sound gets clear after that.
We know you have a choice and appreciate your business. I am so happy getting it fixed. I've checked and reqired everything, I've unpluggedit over night, and I reset it to defaults per the instructions in the manual. Everything on my unit seems to function properly except it is unable to receive any input signals. You saved me soooo much. Hook up your speakers first and give it a try.
I also ran the audio level config for each speaker and where there should be a tone coming out for each channel, there is nothing. I was watching a movie the other the day the sound suddenly dissappeared. The guy said it worked 100%. I had same problem as above. He's probably thinking of the Control 1x speakers which are 8 ohm 80 watt speakers. Jerry Boise Palaboy is incorrect. All of the other coils approx 4 showed a resistance of about 0.
I found this post, and changed the L7002 component with the L7502 after testing them and finding the opened component L7002. I tried a few tricks I saw on the Internet hold the Speaker A and Video 1 buttons to reset and unplug the power cable for 30 minutes to clear out any memory and those did not work. With this function you can assign digital audio inputs to input sources. I performed the same swap and now my receiver works. Only the receiver, no original remote or mic.